SHOWTEC Giant Guía de usuario descargar pdf (Pagina 9)

Backside

Fig. 2

3 4 5 6

3) Blackout Jack Plug for connection optional Remote control (43021)

4) IEC power connector + Fuse 2A 250V

5) DMX signal connector (IN) 3-pin

6) DMX signal connector (OUT) 3-pin

Installation

Remove all packing materials from the Giant XL LED. Check that all foam and plastic padding is

removed. Connect all cables.

Do not supply power before the whole system is set up and connected properly.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Connect the device to the main power supply. The device can be music-controlled by its built-in

microphone.

Control Modes

There are 4 modes: • Select built-in programs

• Sound-controlled

• Master/Slave

• DMX512 (14 Channels or 8 channel )

One Giant XL LED (Built-in Programs)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the Giant XL LED is not connected by a DMX-cable, it functions as a stand-alone device.

Please see page 14 for more information about the built-in programs.

One Giant XL LED (Sound-control)

1.Plug the end of the electric mains power cord into a proper electric power supply socket.

2. Turn on the music. If the device is set to and you have pressed enter, then the Giant XL LED will

react to the beat of the music. Please see page 14 for more information about the sound-control

options.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Sin comentarios

SHOWTEC Giant Guía de usuario Pagina 9