SHOWTEC Compact Power Lightset V@ Guía de usuario descargar pdf (Pagina 10)

Multiple Compact Power Lightsets (DMX Control)

1. Fasten the effect light onto firm trussing Leave at least 1 meter on all sides for air circulation.

2. Always use a safety cable (ordercode 70140 / 70141).

3. Use a 3-p XLR cable to connect the Compact Power Lightsets and other devices.

4. Link the units as shown in (figure 3), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

5. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the

other end of the mains power cord into proper electric power supply sockets, starting with the first unit.

Do not supply power before the whole system is set up and connected properly.

Multiple Compact Power Lightsets DMX Set Up

Fig. 3

Note : Link all cables before connecting electric power

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Sin comentarios

SHOWTEC Compact Power Lightset V@ Guía de usuario Pagina 10